I am including the engine. Had close to 70PSI when I last checked with a friends dynamite thinger. Since then I have put 6 tanks threw. I am on the end of the 3rd gallon... The engine is a .12 CV-R non pull start. The previous owner of the engine broke a screw holding the head down to the crankcase so the head is heald down by 3 screws. I have a brand new CV-R crank case in package that cost me wayy to much to get. All you need to do is convert everything over. Has aftermarket head. Few scratches on head from when I had the truck upside down on the garage floor. So it wasn't from rolling with no body. I also have a new screw kit for holding the head down. Also including new gasket set for it along with the stock head. Has header tha was cleaned up and made sure it was flat.
Nitro Rustler
.12 CV-R non pullstart
Full Ball bearings
Extra spur
Losi Step pins in rear (%75ish life left)
Losi fronts, Have ribs and some knobs, very sticky like new.
Dish rims
Atomik body in picture, kinda hacked but good beater body.
Crowd Pleaser GT body, not pictured Not painted will be blue and silver
Stock arms and plastic around gas tank have been shaved down for lighter weight.
Stock chassis,
Blue Titanium links
Titanium hing pins
RD A-Arms all around, Scratches from use, Still look good.
RD carbon fibre front shock tower
RD carbon fibre front tie bar, broken on end.
RD carbon fibre upper deck
GPM Front blue alum balk head, Has one stripped hole, holds jus like new with lock tite, Can JB new threads in. Nothing big at all
GPM Front C-hubs
GPM Front steering knuckles
GPM Rear Hubs
Extra GPM blue alum front shock tower
Rear shock tower is a homemade cheapo alum one. Not expensive for a new one.
Steel out put yokes
Big bores in rear, Big bore caps on front shocks.
4 blue springs, 2 black, 2 red.
I will start at 230 plus shipping. Honestly I think thats a give away. I could easily get way more... I jus need to sell it...One other thing. With me explaining the small things you should feel very comfortable buying it.
Can e-mail me at [email protected]
-Matt
Nitro Rustler
.12 CV-R non pullstart
Full Ball bearings
Extra spur
Losi Step pins in rear (%75ish life left)
Losi fronts, Have ribs and some knobs, very sticky like new.
Dish rims
Atomik body in picture, kinda hacked but good beater body.
Crowd Pleaser GT body, not pictured Not painted will be blue and silver
Stock arms and plastic around gas tank have been shaved down for lighter weight.
Stock chassis,
Blue Titanium links
Titanium hing pins
RD A-Arms all around, Scratches from use, Still look good.
RD carbon fibre front shock tower
RD carbon fibre front tie bar, broken on end.
RD carbon fibre upper deck
GPM Front blue alum balk head, Has one stripped hole, holds jus like new with lock tite, Can JB new threads in. Nothing big at all
GPM Front C-hubs
GPM Front steering knuckles
GPM Rear Hubs
Extra GPM blue alum front shock tower
Rear shock tower is a homemade cheapo alum one. Not expensive for a new one.
Steel out put yokes
Big bores in rear, Big bore caps on front shocks.
4 blue springs, 2 black, 2 red.
I will start at 230 plus shipping. Honestly I think thats a give away. I could easily get way more... I jus need to sell it...One other thing. With me explaining the small things you should feel very comfortable buying it.
Can e-mail me at [email protected]
-Matt
Nice to see you again.
