homebuilt 4 wheel steering t-maxx

[bashmaster]

get 2 front assemblies of a t-maxx and put one on the front and one on the back, add another servo mounted just under where he header comes off the engine, and then hook it up to a y-harness leading to the other steering servo and hook into the steering channel slot on the rx...

sounds pretty simple to me

i may have to cut the wires on the second steer servo to reverse the polarity to get the opposite action out of the servos. but i havent started it yet so I'm not sure.

 

[Green Hornet]

i was thinking the same thing with my ofna buggy......i might start messing with it after the new year.

 

[Domination]

thye have a coversion kit for the t-maxx for 4 wheel steering

 

[bashmaster]

yea iknow theres a conv kit but this is a dirt cheap way of doing it

 

[XXXsTeve]

All you have to do is pop out the ground wire and switch it with the positive wire. Depending on the servos you use the ground is black and the positive is red, not always though. :stickup:

 

[RiceLaxer06]

what if u just got one hi torque servo and attached it to both steering set ups?