Help Please Spur & Clutch Bell

[bigjayjay1]

I just installed a .26 max Picco with Ofna mount and I noticed my spur gear (Side) is touching the clutch housing is their a adjustment I'm missing or is that normal. When I turn my clutch bell when the revo is on my stand theirs some friction but not much but I would like to have a small gap between the spur and clutch bell. The motor is pushed back as much as possible VIA 4 screws which secure through the OFNA mount and the Transmission is secured correctly. Any suggestions.

 

[hpiracing1123]

put on finger on ur clutchbell and another finger on your spurgear and move your clutchbell until there is little or no play in the clutchbell.

 

[Captain Chaos]

You are limited to what gear ratio you can run with the offna mount.You need to:
A - grind out more adjustment in the slot
B - run a smaller spur or bell
C - I have read the New Era mount resolves this issue.

 

[bigjayjay1]

Thanks I actual bought the new era yesterday hopefully it work the ofna mount is not great but cheap the era was 40 buck. Thanks for the reply