gs .21

[kraut68]

Does anybody know what the factory needle settings are and proper break in procedure for the GS .21? Thanks for any help.

 

[kraut68]

I found the settings. Here they are since nobody here knows.

Hight speed: Just below flush.
Low speed: 3.5 turns out
Idle: .7mm to 1 mm


http://www.gsracing.com/gsracing/page.asp?pg=support&id=2#FAQ

 

[nitromaniac]

Originally posted by kraut68
I found the settings. Here they are since nobody here knows.

Hight speed: Just below flush.
Low speed: 3.5 turns out
Idle: .7mm to 1 mm


http://www.gsracing.com/gsracing/page.asp?pg=support&id=2#FAQ

this is almost right,, heres what they are

HSN 3 1/2 turns out
LSN flush with carb , then 1 full turn in
Idle stop is correct but you shouldnt need to touch it!
good luck!

 

[HumboldtBlazer]

I would't say nobody here knew. I would say somebody new here didn't search

Originally posted by humboldtblazer
Its not in the manual (bad thing)

ok the mystery is solved. YOu were pretty close in your guessing
HSN 2.5 turns out
LSN 3.5 turns out
Idle about 1-1.5 mm gap

So you were a little lean on the low end (but not really since 3.5 is factory=rich) and a little rich on the high end. Good luck.

https://www.rcnitrotalk.com/forum/s...=5558&highlight=storm+factory+engine+settings

btw that is from a GS employee not me.

 

[kraut68]

Thanks. GS gave me the link for these settings. So between the two, I should get be up and racing. Thank again.

 

[HumboldtBlazer]

I am glad they posted it finally. It took me and a lot of other talking to the guy I know at GS to get that to come about. Would be a no-brianer imo but they just got that up as of that earlier post I sent you a link to.