Lets try this again. Over $700 invested. No more then 1hr Total RUn time on any of the components. Id like $300 OBO... This this is collecting dust. So Make me a offer.
Ratzas chassis and T plate
Ratzas Rear Deck w/ shock and springs
370BB motor from blind batteries
Golden horizons: Alum Pulley
Golden horizons Ball diff.
Golden horizons one way diff
Golden horizons Alum Upper Bulk
Golder Horizons: Front Shocks
Hot Bodies: alum steering knuckles
HPI: Steel dogbones
HPI: rera ball diff
HPI: Steel pinion set
Front lower a arm alum. either Golden horizons, or hot bodies. not sure
aluminum rear pod: pretty sure its Hot Bodies
HiTech HS-81MG servo
Futaba MC230CR Speed Control
Futaba R133F 75mhz 3ch. FM receiver
(2) 6cells one 1100mah and one 1000
Jaco foams
corvette body
Added the 370bb and deal Untra plugs after pic's will take current one if someone wants.
ok a few pic's...... ( large pic's )
http://www.cecoatings.com/images/RCStuff/microRS4/
Ratzas chassis and T plate
Ratzas Rear Deck w/ shock and springs
370BB motor from blind batteries
Golden horizons: Alum Pulley
Golden horizons Ball diff.
Golden horizons one way diff
Golden horizons Alum Upper Bulk
Golder Horizons: Front Shocks
Hot Bodies: alum steering knuckles
HPI: Steel dogbones
HPI: rera ball diff
HPI: Steel pinion set
Front lower a arm alum. either Golden horizons, or hot bodies. not sure
aluminum rear pod: pretty sure its Hot Bodies
HiTech HS-81MG servo
Futaba MC230CR Speed Control
Futaba R133F 75mhz 3ch. FM receiver
(2) 6cells one 1100mah and one 1000
Jaco foams
corvette body
Added the 370bb and deal Untra plugs after pic's will take current one if someone wants.
ok a few pic's...... ( large pic's )
http://www.cecoatings.com/images/RCStuff/microRS4/
Last edited: