flywheel not turning with glowplug in ????

[raff113]

hi guys got bit of problem my flywheel does not turn when i have my glowplug in and when i use the pull start its abit stiff and when i take the glow plug out the flywheel seems fine , its not flooded and i allways use afterrun oil , I'm scatchin my head so need sum help.

 

[frickenjoey]

So with the glow plug out it is fine....well it just sounds like the engine has a lot of compression then. Have you tried starting it? If an engine has a lot of compression it is normal for it to be difficult to turn the flywheel by hand. When trying to start it I would crack the glow plug a half turn to release a little pressure and see if it will start. If it starts just tighten the plug back up and go bash.

 

[2revo1maxx]

Too much after run oil will flood the engine.
I think you just need to pull it over a few times upside down to clear it out....with the plug out.
If that's not the problem then warm it up with mom's hair dryer.

 

[raff113]

ill give it a go ,ill use the misses hair dryer thanks guys

 

[raff113]

tryed your ideas no look so ended up taking engine apart seemed when i moved the piston it would force shimes to rise apart from that was ok put it back together and it worked so still no idea wot was up with it.