EZ-Start not showing glow connection

[RedInNC]

I can't seem to get the EZ-Start to ignite the glow plug. I've replaced the lead blue wire on the wire harness, battery is good, replaced glow plug, but to no success.

I was about to try my igniter for my Savage but thought a quick post may result in suggestions.

Thanks in advance.

 

[RC Addict]

Ditch the blue wire and use the glow plug igniter. I would go to a pull start if it were me.

 

[black4x4]

ground wire? (yellow wire) yeah just go with the glow ignitor

 

[JessF]

make sure your 7.4v battery is fully charged, and I mean warm to the touch and fully amp'd up.

 

[bassman]

I have the same problem. I just went and bought a ignitor and it works great.

 

[Rolex]

There's a circuit board in the start wand. A component on that board that goes to the glow plug has a problem. Go with the ignitor.

 

[RC Addict]

make sure your 7.4v battery is fully charged, and I mean warm to the touch and fully amp'd up.

That isn't a full-proof way to determin maximum charge. :\