- Messages
- 9,066
- Reaction score
- 291
- Points
- 823
- Location
- Baton Rouge, LA
- RC Driving Style
- Bashing
- Racing
Will a mamba brushless setup for a 1/18 fit in a 1/16th?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Engine fit?
- Thread starter alpinehyperlite
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
CharliesTheMan
Gone - bye bye.
I just did some checking and came up with some good news. The mini inferno that you have uses a 380 size motor configuration. I checked and the Novak Mongoose brushless system uses a 380 sized motor, so it should fit right in. I think the castle motor is a 280 size so it may not bolt right in. Golden Horizon also makes a nice system in a 380 configuration that fits right in.
Last edited:
- Messages
- 9,066
- Reaction score
- 291
- Points
- 823
- Location
- Baton Rouge, LA
- RC Driving Style
- Bashing
- Racing
- Thread starter
- #3
k. Thanks, id have to order somthing then. Hobby towne here in br just got the mamba for the mini-t and i was just checking if it would fit.
I had a hyperion 6000 in my mini lst and it was fast. It is a 300 size motor or you could go with a wraith 7000 which is the same size. They both should bolt in. The wraith could take at least 6 months to get. The mamba should fit in but it is smaller so it won't be as fast.