converted tmaxx clutch assembly

[ToRqUe1]

waz up, I'm not new 2 r/c but i have been away for a few years. i jumped right bak into it and ofcourse I'm comming across some problems. I have a convetered T-Maxx on 1 end of my table and on the other end i have a mach .26 . The t-maxx's stock flywheel doesn't fit on the machs shaft, and i went to the hobby shop 2day and 1 guy told me i had 2 use the stock tmaxx clutchbell(i think hes wrong) Basically my question is...what assembly do i use for my flywheel and the clutch/clutch bell ???

please be specific cause clutch'es are my week point.

 

[Lessen]

You need a flywheel/clutch assembly that is designed for big block engines. That is.. engines equal to or larger than .21 displacement. You will also need a different spur gear because big block setups are of a different type of 'tooth'. RC Solutions makes a couple spurs for the T-Maxx that will suit your conversion.

 

[ToRqUe1]

so basically i can use any type of flywheel and clutch assembly that pleases me ?,
and the only thing that must get is the spur gear that is made for a big block tmaxx?