cleaned carb & now no start

[95ram]

So I cleaned the carb the other day and I went to start it up today and it just wouldn't go. It would turn over and sound like it wanted to start but wouldn't. I set the carb back to factory specs. All the orings looked good. I also sealed up the rear on the ez start with RTV. Got any ideas on what to check.

 

[Tmaxx96]

the settings are at
HSN: 4 complete turns out (8 half turns)?
LSN FLUSH?
and is your idle set to a 1mm opening ???? here check this out maby it will help

http://thetoyz.com/forums/index.php?showtopic=19014

hope this helps Thanx Nate

 

[gnarkill]

did you replace the oring?

 

[darnoced]

Is the locking bolt snug? How does the glow plug look? Is the carb slide rubbing against the Ez start?

 

[95ram]

the settings are at
HSN: 4 complete turns out (8 half turns)?
LSN FLUSH?
and is your idle set to a 1mm opening ???? here check this out maby it will help

http://thetoyz.com/forums/index.php?showtopic=19014

hope this helps Thanx Nate

I reset the carb to the factory specs. 1.5 on LSN, 4 on HSN and about 1mm on the idle. Also the link no worky. Says I have to log in.

did you replace the oring?

I did not replace the orings

Is the locking bolt snug? How does the glow plug look? Is the carb slide rubbing against the Ez start?

the bolt is snug. The plug looks good and lights up good. The carb was hitting the ez start, but I adjusted that.

 

[darnoced]

The only thing I can think of is that the fuel is not getting into the engine. Maybe a bit of dirt got inbetween the HS and the carb throat and is plugging the works up.