• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

carburator question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
T

tam13

RCTalk Qualifier
Messages
174
Reaction score
0
Points
0
RC Driving Style
well it seems like everytime i press the throttle the carburator shakes so I'm pretty sure its loose. and it seems like i burn out glow plugs like every 3 mins. so if the carburator is loose will it cause any problems I'm going to tighten it either way but i want to know if i will cause any problems and also it is very hard to start my maxx.
THNX
 
tighten up the carb by just turnung the carb nut clockwise. and then richin it up to not burn out plugs, (start at factory settings and then lean like you were breaking in until it stops burning plugs)
 
on the side of the carb. there should be a little hole with a rod going through it. at the end of that rod there will be a nut. tighten that nut down and it should hold the carb in better. it is hard to start because it is leaking air into the engine, causing ultra lean conditions. If run long enough like this it could cause a problem. but if u havent run it alot like this there shouldnt be a problem.
 

RC Builds

Back
Top