I upgraded my brakes to the disk brakes on my .21 then I totaled that so I was swiching them out to my .25 and somthing is not right. Dose anyone have the directions that they could post for me so I can see what I am doing wrong. Thanks Tim MI
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
brake question
- Thread starter Bigdog
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 19,394
- Reaction score
- 909
- Points
- 2,075
- Location
- Central Florida
- RC Driving Style
- Bashing
- Racing
- Thread starter
- #3
thanks but the upgraded brakes have the dual disks and there is a gasket of some sort that I am not sure where they go and the venting on the disks do they go out away form each other or do they go in twards each other. thanks for the help Tim MI
TRDStreetFighter
RCTalk Addict
- Messages
- 547
- Reaction score
- 0
- Points
- 0
- RC Driving Style
okay if you have the Hot Bodies brake system
1. glue the carbon pads on the stock metal calipers
2. the blades should be facing each other... this give the vent/heat sink
I just got my new pads and did this morning
1. glue the carbon pads on the stock metal calipers
2. the blades should be facing each other... this give the vent/heat sink
I just got my new pads and did this morning