Axial UTB10 Capra 1.9 4ws

[Rainbow9]

A few weeks ago I got new Axial utb10 capra 1.9 AXI-1543T2. Like this rig, but have a tecnical issue: rear steering is not turning evenly. can't make any adjustment in DX3 transmitter, turning the designaterd knob. Left turn goes all the way, but right tutn just 50% at most. I followed the manual, wached videos on youtube - nothing is help. I sent email to Axial customer service, waiting to their respond. Does anybody with this model having similar problem?

 

[CertifiedMike]

I don't own one of these. My first thought would be to inspect for any physical binding. If you turn the wheels by hand, does everything turn smoothly and as expected?

 

[Rainbow9]

I don't own one of these. My first thought would be to inspect for any physical binding. If you turn the wheels by hand, does everything turn smoothly and as expected?

Thanks for respond. no visible damage on steering links, or other parts. For some reason steering servo doesn't travel to the right as long, as it does to the left. But in defolt position servo horn stayes on the middle and wheels also stay straight. I tried to turn rear wheels by hands, as you asked, and they are going all the way to both direction. My thoughts - transmitter not communicating with servo to adjust its travel both way evenly.

 

[WickedFog]

Thanks for respond. no visible damage on steering links, or other parts. For some reason steering servo doesn't travel to the right as long, as it does to the left. But in defolt position servo horn stayes on the middle and wheels also stay straight. I tried to turn rear wheels by hands, as you asked, and they are going all the way to both direction. My thoughts - transmitter not communicating with servo to adjust its travel both way evenly.

Sounds like you need to reset your servo endpoints. Look up how to do that on your transmitter.

Also, I would pull the servo horn off. Tutn the rasio and truck on. Make sure the trim for that servo is at zero, and reinstall the servo horn as close to center as you can. Then set your trim to center the steering, then set the endpoints.

 

[CertifiedMike]

Make sure the servo saver itself is not damaged or stripped too.

 

[Rainbow9]

Thanks WickedFox! I will do reserches on that