Axial .28 conversion on 3.3 help please

[Tmaxx.28]

I just purchased a Axial.28 BB to replace my 3.3 i have the new mount but I'm just lost on what to do anyone know what to do or how to go about doing this??

 

[MMGT55]

Well make sure your carb is in the same position as the stock one. Switch over the clutch bell,shoes,and etc. Mount it in place and break it in.

 

[Tmaxx.28]

But dont i need to drill holes and modifiy the chassis... I see online they sell a diffrent one made for the t maxx with a .28

 

[MMGT55]

No if you bought a big block conversion kit then no you wont need to buy anything else. If your trying to stuff a big block in the maxx without the kit then you will need to drill special holes in the chassis. If you do make sure the lines you drill allow a good gear mesh.

 

[.21Rc10GT]

I just purchased a Axial.28 BB to replace my 3.3 i have the new mount but I'm just lost on what to do anyone know what to do or how to go about doing this??

If you already have the mount for the BB, then there is no need to modify the chassis. You will need a new header and pipe, if you haven't taken care of that yet.

 

[Tmaxx.28]

I just have the engine mount thats all anyone know where i could find the whole conversion kit

 

[frickenjoey]

YES I sure do one of our members has one for sale....link attached
https://www.rcnitrotalk.com/forum/showthread.php?t=67406

Hmmmm it looks like he is off reading the rules right now.....might be a few days before he gets back.

 

[Tmaxx.28]

yea i seen that Only thing its purple....

anyone know a good clutch bell, spur gear, and a header for a .28 too

 

[Tmaxx.28]

perferably for all around power

 

[frickenjoey]

This will have pretty much everything that you will need for the conversion.
http://cgi.ebay.com/DYNAMITE-DYN7402-T-MAXX-2-5-BIG-BLOCK-CONVERSION-NIB_W0QQitemZ270348569272QQcmdZViewItemQQptZRadio_Control_Parts_Accessories?hash=item270348569272&_trksid=p3286.c0.m14&_trkparms=72%3A1205|66%3A2|65%3A12|39%3A1|240%3A1318|301%3A1|293%3A1|294%3A50

 

[Tmaxx.28]

i almost got it on the stock chassis cut out a bigger opening so i could slide tranny forward more and to make room for the brake thats why i was wondering on the ckutch bell,fly wheel and header to get

 

[MMGT55]

PM Sent