• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Ahhh some problems today!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
H

Hpisavagecrazy

RCTalk Basher
Messages
44
Reaction score
0
Points
0
RC Driving Style
Well if you dont allready no....I'm running a wasp 28. only about 2 tanks in it...i was running it today and.....i would heat it with a blowdryer till 100 degress and then i would fire her up...it would run for about 10-15 seconds when I'm doing figure eights to break it in...and it would just stal....i would have to keep restarting it.....could this be a tunning problem?.......And another thing is My damn breaks wont work...i have the good dual disk breaks allso...worked great when i first had them...now they dont work at all now...caused alot of curb bashing to the truck....could getting them wet be the problem and :devious: i would have to bye a new set...cuz there only about a week old with only driven like 2-3 times on them!!!PLEASE HELP@!!!!!!!!!!!!!! :cheers:
 
The stalling issue is tuning.
Your brakes might have become dialed out on your radio.
Check the throttle/brake setting on the radio with the truck OFF.
See if you can adjust it that way first. Water should have very little affect.
PS. Stay out of the water.
 
Check the two screws holding the brakes, they might have vibrated loose. Just be lucky you didn't jump 15 ft in the air and realize you have no brakes like I have.
 
sweetdiesel said:
Check the two screws holding the brakes, they might have vibrated loose. Just be lucky you didn't jump 15 ft in the air and realize you have no brakes like I have.
Click to expand...
no iwas jst going top speed with my wasp and reilzed i had no brakes and BOOM there it hit.....luckly nothing broke :shrug: yeh but tomarow me and 1 of my friends will have to take a look at it!
 
Why were you running top speed, when you're only on tank 2 of the break in?
If you don't take the time to break it in properly, it will have a very short life.
 
Rolex said:
Why were you running top speed, when you're only on tank 2 of the break in?
If you don't take the time to break it in properly, it will have a very short life.
Click to expand...
well it really wasn't top speed it was about 3/4 throtel.....bout 3 tanks into it....but it was only once....lol i got greedy!
 

RC Builds

Back
Top