• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

After Market Parts for Racers.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
brmax said:
Racing Parts for the Revo
1. Forward only Conversion $12.50
2. Motor Saver Air Filter $15-25
3. Trinity or Resonator Pipe $40-60
4. Rpm A Arms $50
5. Tekno Throttle Mount $15
6. Single Digital steering servo $30-130
7. Sway bars $30
8. Tenko battery box and gas tank conversion $ 25
9. P2 rockers (stock)
10. 10k-50k Front and rear diff oil $12-20
11. Center Diff 500k oil $50
12. Bow-Tie Tires $50
13. Dish Rims $ 20-40
14. Tekno Wing Mount $10
15. Proline Downforce wing $17
16. 17mm hubs $23
17. Aluminum Push Rods and Turnbuckles $50-70
18. Fuel Filter $7
19. close-wide ratio trany gears $8
20. Rear Brake ( must with center diff) $20
21. Steel Constant-Velocity Drive shafts $80

This is just for a reference for newbs.
Click to expand...

any chance of someone doing a list like this for a GT2?
 
brmax, thanks for putting that list together!! I'm a newb and this list really helps me out!! Although I'm a basher and not a racer this still gives me ideas about what to upgrade first. I was looking at the RPM true track rear end and front arms, simply because they are made from such study material. My LHS carries their stuff and is surprisingly competitive with on-line prices.
I got the RPM front/rear bumper set yesterday as well as a motor saver air filter. I love new parts.
 
Scrogg said:
My rpms popped out on the very first run. i was pretty disappointed, the stockers held up better, not to mention I lost some steering due to the thicker material around the pillow ball carriers.
Click to expand...


I have had the same experience with the RPM axle carriers also.I was talking with two other guys at thew track with the same problem.The steel reinforced platinum carriers are working great so far.I think RPM needs to look into the problem.I have put the balls back in and used them again with the same results but it does not take much to pop em out when new.
 
Steel reinforced carriers? I missed that one.
Believe it or not my GH al. carriers are doing quite well with Ti. pivot balls. No breakage since I put them on.
 
I will do some research over the next couple of day and make a list for the gt2. Your welcome guy this post is getting used for what i ment it to be :) Helping out fellow revo lovers.
 
i have done enough researching and the list is goin up tomorrow on gt2 :)
 
Nice Revo, Working on upgrading my new Revo 3.3. They have a lot of upgrades already but still a lot of work.
 

RC Builds

Back
Top