• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

After bashing it works but dont go

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

DoiniT

RC Newbie
Messages
6
Reaction score
0
Points
0
RC Driving Style
  1. Bashing
went out aftr second tank it died from wastein all the gas dnt kno y went i turn it back on it revs up but hardly moves like it anit catching itself it turns on perfect nothing wrong also i notice on top of the pipe next to the fuel line lil air bubbles come out any comments ??
 
the high rev may be caused from the airbubbles in the feul line, the air causes it to run lean. blow air bubbles out of fuel line then restart
 
Check your slipper, It's possible the nut in the center of the slipper is loose, or you may have damaged the spur gear itself. If it's not the slipper, or spur gear, you may have clutch issues.
 
Wont run

Sounds like a issue i just had,shredded spur gear may well be the problem..the plastic ones will run down pretty fast if your bashing it about alot. £4 off ebay for new one..or a steel one for about £12 may be a better option..
 
My xl runs good motor wise but no power to wheels. It moves but revs high no burn outs not sure what to check first.
 
Back
Top