3.3 integy motor mount

[alman]

i was wondering if anyone uses the integy machined mount if so have u liked it? i have heard that it can cause the tabs on the mill to break cause it is stronger and they are the next weakest point so give me your thoughts or experinces

 

[destrucktomaxx]

General consensus says stay away from Integy anything really...

 

[alman]

yea i have heard that but i dont know of anyone else that makes one. but i have added a wing so that should help out when i land on the lid

 

[destrucktomaxx]

There's lots of company's out there that make motor mounts for the 3.3 bud, just Google it and you'll see.

 

[Scrogg]

The stock mount works just fine IMO. I took the serated washers out so the engine mount would slide down on any really hard impacts.
Integy does make some good parts. Their al. rear skid plate for the Revo is awesome. It fits just like the stocker and lasts forever. My Revo would eat away the stock plastic ones in one race.
Their hubs for the Savage are tough as hell too. The front al. carrier hubs for the Savage increase steering throw a lot. The Integy shocks do suck though, purely shelf queen/street truck shocks.

 

[RevoRacer.27]

Stay away from anything INTEGY except skids i guess. The stock mount is fine, but if you have to change it go with new era before integy.