2nd gear

[mpatterson136]

my last run my revo was fine,i followed after run procedures I upgraded to a battery pack took it out today burned up my throttle servo and will not shift into 2nd replaced servo put settings at factory still wont shift. I only have a 1/2 gallon fuel burned through it since new(1 month ago)do I need to adjust clutch or does anybody have any idea what I'm doing wrong!!!!

 

[syphon68]

more than likely it will not shift into second because it isn't tuned. How did you break it in? keep an eye on your temps but lean it out a little on the HSN and see if your top end gets better to where it will shift.

 

[solly69]

my HSP Atomic Warhead doesn't change gears and i have no idea why
I'm still a noob to RC

help guys

 

[Bartek]

did you set the second gear?
I'm not sure how is it done on Warhead but in Revo you can set when truck should switch to second gear by adjusting a screw.

 

[GrudgE]

I f truck was shifting fine before I doubt the shift point is the problem. I would suggest starting fresh at factory settings and retune.

 

[solly69]

i dont think it has ever changed gear
well not that i can notice anyways

 

[RusTLeRx350]

Lean it out. It's probably too rich...

 

[auhutchi]

I have the 5308 model. My revo stopped going into 2nd gear also. Once i changed battery's with fresh ones it started going into 2nd gear again. Make sure you have fully charged batterys. If you do then try leaning it out and make sure your slipper clutch isn't to lose