• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

2075 servo's

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
X

XxVASSAGOxX

Gone - bye bye.
Messages
444
Reaction score
0
Points
0
Location
Hickory N.C.
RC Driving Style
  1. Bashing
  2. Racing
hey will the 2075 waterproof hi-torque servo's fit perfect in a revo 3.3?
there 125oz each in torque and my freind has them for $50 for the pair brand new, i figured thats a good upgrade from the stock servo's right?
 
Yes they are a direct swap and perform much better than the 2055's.
 
If the torque of one is equal to 2 of the others then yes, you can run the one and assume you'll get the same performance. However, you must also consider than 1 servo is going to take on twice the load as each of the servo's in a dual servo application so one servo probably won't be quite as durable as twins would be, although it should still hold up fine.
 
food for thought

the 5308 revo only comes with one servo and works just fine. If you are conserned about loading and stripping it, then adjust your servo saver accordingly. If you can get a good deal on two, get them, but have one for a back up. Now you rcvr pack will only have to power 2 servos instead of 3.
 
ok i picked up 2 brand new 2075's for $48 and i got a venom 6v 1600mah battery for $17 so i think I'm set, thanks
 
I am running single steering with a single 2075 havent had any issues yet. I am also running a a 2075 for my throttle.
 
hmm really? now i was set on keeping 2 servos for steering for the forceful responce on hair pin turns? but you say its perfect with 1?? i ordered 2 at $24 each i coulnt pass that up
i was gonna use a 2055 for throttle
 
XxVASSAGOxX said:
hmm really? now i was set on keeping 2 servos for steering for the forceful responce on hair pin turns? but you say its perfect with 1?? i ordered 2 at $24 each i coulnt pass that up
i was gonna use a 2055 for throttle
Click to expand...
Do that, 125 oz. of torque is barely sufficient to turn a monster truck.
More torque on steering is always better, reduces the load on the servo(s).
 
yea i decided to use 2 2075's and the venom 6v pack. and yes i have ground the tabs on the plastic peice for more turning
 

RC Builds

Back
Top