.15 to 3.3 slide carb help

[sata1991]

well got my w2s =) so i will be getting some cash back i am going to get a 3.3 or the picco .26 for my maxx my question is i need to install the tower to run a slide carb where do i drill my hole at. and yes i have done the 3.3 drive line swap lol.: thanks

 

[Snook Man]

 

[nikko508]

Line up the linkage from the throttle servo and the linkage from the carb make sure they are straight as possible and at the point that they meat is the location that the post needs to go drill all three holes just the pict that snook man sent you and install the post make sure its not touching any thing or it will bind up and you should be go to go no big deal I did it to mine it took about an hour total. My question is what did you replace on the drive line I didn't replace anything and its all good.

 

[Ballen]

the conversion comes with a templeat (mine did)

 

[sata1991]

i replaced the a arms drive shafts turnbuckles axle carriers =) thanks guys ya the .15 is on its last leg lol