Search results

Before i snapped the pull start i noticed that after lowering the revs so it doesn't drive away from me the clutch still spins I can't seem to get the revs much lower without it cutting out on me and when the clutch is spinning it turns the big cog but that doesn't translate in the output shaft...

The back and forth motion was happening cause I was lifting the wheels and putting it back down, but regarding the diffs being built correct they are missing a piece so I've ordered it and will get it put in when it arrives. Its clean cause I spent a while cleaning everything and building it...

sorry no the shaft started spinning when I lifted the wheels. Ended up snapping the pull start so can't do any testing at the moment :(

Sorry yeah it is and when the car spins up the wheels go faster but they only spin up in the air.

All the gears are making good contact so that won't be the issue :( what are the wheel pins you're on about? Quite new to all this

I'm very new to all this so thanks for the advice, I found a manual with all the default settings for the idle speed and carb and set it up. Now it doesn't roll away from me and when I accelerate with the remote it's like i have to tap the throttle to get it rolling. Would you be able to help me...

Here is a video of the rc car I have to hold it as when I let go it starts rolling slowly, when the gear starts spinning faster that's me lifting the car off the ground, hope this helps.

Got some 80 grit to it and still the problem persists. From what I seen the clutch looks fairly symmetrical so don't think it's installed wrong. As I said above to @AClegg it rolls pretty swiftly and when I add more throttle the engine spins up but this doesn't translate into the car rolling any...

Cheers mate but don't think mine has one, don't think so anyway I don't know

Really starting to think it may be the clutch, but the clutch was just replaced, what about the bell housing do they need replaced?

I've just went and started it up again and it rolls by itself, the throttle changes engine rpm but not the speed of the car. When it's rolling its like a decent walking pace roll.

Is that the spring that goes around the clutch shoes? It's brand new so I don't know why it would be that, unless it was a bad quality one cause when I got it off my friend it came with a replacement clutch in a sealed packet

Thought this too but I replaced the clutch shoes when I took it apart

Yep it revs really high I'd say.

I recently got a kyosho inferno mp7.5 from a friend that couldn't get it working and he got it from a friend. I've stripped it down and gave everything a nice clean and put it back together following the instructions. Everything seems to work but when i accelerate the car barely rolls. Any idea...