Where si the tutorial for soldering a charge jack to the transmitter circuit board?

[knall]

I am sick of takin the batteries out..... anybody got a link to this mod?

I remember seeing it..... all I realy need to know is where to solder the wires.... and how to check for correct polarity.

THANKS!! I know its on here someplace

 

[moe7404]

i wired my hand wand to go to the sig outlet on my street truck. got the connector for the wand and black/red wire and sig out let conector from radio shack. this puts 12 volts d.c. to the 3.3 starter motor. after 5 mo no trouble. this doesn't charge the 7.2 v batt it takes it out

 

[knall]

http://www.rchangout.com/forums/showthread.php?t=14785

Found it.....

I wound up just soldering to the battery box..... as long as you dont turn it on during the process its fine.

Did it tonight..... works.....charegd it and ready to go. never have to take the batteries out again.

 

[moe7404]

i didnt understand what bat charger (voltage ect) he was using. or how he wired the switch. i have started a project it use the 12 volts on my street truck and regulate it to 1.5 v for the glow plug. cause i have found that nimh bats drop voltage very fast. my test showed the glow plug are not real brite when the voltage gets down to 1.2.