T-maxx with mach 26 good setup or bad

[newtorc]

i got this on a trade with one of my buddys i got it with this setup on it and i was wondering if it is a good engine.. i have been haveing a problem tuning it in one day it was running sweet and then all of the sudden it stalled and i could not get it to start again... so i let it be and the other day i was running it after it rained it ran sweet after adjusting the mix it was kinda humid but the thing is that it would bog at wot but if i let it set and idle for about 30 sec. and punch it the thing would run sweet for about a 1 min and then the bog is back at wot then it stalled and it would not start again but it was not hot i could still touch the head... and the pullstart is acting up i took it all apart to clean the oneway bearing put it all back together test the pull start and it worked cool went to fire it up today and the damn thing was acting like it was dirty inside and it kept skipping...

biggest issue is the tuneing i can't get it to run consistent and smooth

it has a 19t clutch bell and a 65t spur is the speed or acceleration
the help would be greatly appreciated

i want to beat my dad's t-maxx thanks newtorc

 

[jay3]

Most likely is very rich. You can tell its too rich when it bogs up and the engine isnt too hot. Thats why your getting bad performance most likely. Is there a lot of blue smoke/fuel coming out of the exhaust?

Try leaning it a bit.

 

[newtorc]

not to much smoke. after running it for a while it will shut off and start hard or i will have to let set for a bit... only time it smokes is at wot i think i have the air mix set to lean iam not sure i will have to try a lil more tuning