Switching out the steering servo and Pullstart cord

[Andrew1014]

Does anyone have a guide or can tell me how to do it correctly so I don't mess it up?

I'm changing out my ripcord because my old one snapped.
Steering servo because my old one was plastic. this new one is metal.

Thank you very much

~Andrew

 

[beason]

both are pretty strait forward, on the pull start, you will have to remove the engine from the truck. there are 4 screws that hold it to the block. just make sure the one way bearing is on there the right way, and that the center of the pull start doesn't pop out. it has a spring and will pop out all over the place.

the steering servo is different on each rig, should be held down by 4 screws as well. you will have to use a different servo horn screw in the metal geared servo, but it should come with one. just make sure you turn on the truck and let the servo center before you put the horn on.

 

[Andrew1014]

oh, alright. I hope I can get it haha just be careful I suppose. put things back how I first took it apart