Shock Pliers, and Gauges for 1/6 Scale Truck

[Young Padawan]

Greetings,

I am a total newbie to the hobby. I'm trying to find Shock Shaft Pliers for a 1/6 Scale RC Truck (Losi Baya Rey 2.0). The closest I'm finding is for 1/8 and 1/10 scale. Does anyone know of one that would work on 1/6 trucks, or, if the 1/8 scale one would work?

The same question for Camber, Ride Height, and Toe Gauges. Thanks.

Regards,
Young Padawan

 

[bill_delong]

what is the diameter of the shafts?

If they are close to 3.5mm then most 1/8 pliers will work perfectly fine

 

[WickedFog]

These will do.
https://www.amainhobbies.com/hot-ra...end-multifunction-pliers-hrasdp868x01/p650292

My eyes are calibrated to within +/- .25mm, and looking at mine, they would grip all the way down to a 1mm shaft. Sorry, I don't know where my calipers were last used to get a more accurate figure

 

[Young Padawan]

These will do.
https://www.amainhobbies.com/hot-ra...end-multifunction-pliers-hrasdp868x01/p650292

My eyes are calibrated to within +/- .25mm, and looking at mine, they would grip all the way down to a 1mm shaft. Sorry, I don't know where my calipers were last used to get a more accurate figure

Thanks Kevin.

what is the diameter of the shafts?

If they are close to 3.5mm then most 1/8 pliers will work perfectly fine

Hi Bill,

I looked at the both Owners manual and the Parts manual, but the diameter of the shaft isn't listed. The truck will arrive today, and I'll measure it then. Thanks for the reply.

Young Padawan.