Rear Shims on Slash

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

godale03

Awesomer!! Than Rolex!!
Supporter
Messages
6,738
Reaction score
112
Location
Maryland
RC Driving Style
  1. Bashing
Hey Guys,

I was taking apart my Slash yesterday to clean it. I was in a bit of a hurry since time never seems to be on my side... anyway there are two shims that went somewhere on the rear axles. It is a thin and think shim. Which side of the carrier to they go? Does one go on each side of the bearings? Or do they match up and go between the bearing and the hex? I can't tell from the exploaded image, it just shows one shim between the hex and the outside carrier bearing. Thanks

Tom
 
Afternoon Bumpity Bump!
 
If I buy one tonight I'll look at it and let you know.
 
Just took mine apart to check. Thin inside thick outside.

Thank you!! I figured one went on the inside and one on the out.. but just wasn't sure which one went where. Thanks again!

Tom
 
Back
Top