Quick ??

[Reddog]

I am switching out my T Maxx to an extended chassis. I will still use the 2.5 tranny for now. I was needing to know which drive shafts (center) that I need. If there is anything else I need to change going to the longer chassis just let me know. I have the chassis, chassis braces, bulkheads from the 3.3 and the rest will come from my 2.5. Thank You, Shaun

 

[chickenman242]

When sticking to the extended chassis the only dumb thing that took me a bit to figure out was the fact the throttle servo is turned around so the linkages work right , other than that you should have everything covered

 

[savage24x]

You need these center shafts. What you need to do is take off the ends that go into the 3.3 diff casing and put the 2.5 ends on. You'll need to use the 3.3 pins and e-clips. You'll also need two washers to put between the end and the e-clip on both sides.

http://www.ebay.com/itm/Traxxas-490...Control_Parts_Accessories&hash=item58ae19f749

 

[hotrodrob]

Reddog all u really need to do is cut down an old axle to use as a front center shaft, I still have a few 3.3 type front centers laying around if u want one