noob quesition- radio crystal

[bigsouljaslim13]

I need to get a replacement rx and and I'm not sure if i need a 27mhz or 75mhz rx the crystal that was in it is a futuba and it said type 72-11 channel 75.750 on one side and type 72-11 AM Rx on the other.. cuz i found an 75mhz r/x for 27$ and i found a whole radio system with servos for 40$ and everything but its 27mhz will my radio work with that rx? its says 75mhz on the back so I'm guessing i can only go with 75mhz

 

[Monkey Wrench]

What does your TX say?

 

[Monkey Wrench]

Ding Dong (doorbell), anyone home? You going to answer the question or should we just start guessing?

 

[AC48]

If your Tx says 75 you need a 75mhz Rx.

 

[bigsouljaslim13]

whoops

Ding Dong (doorbell), anyone home? You going to answer the question or should we just start guessing?

Sry bout the delay, i havent had much time lately but it was a 75mhz and i just won a hi-tec 2 ch 75mhz on ebay for 20$ total so i should be set now, i managed to pick up some plastidip on the way home from school a few days ago i did the servos but I'm not sure weather i should try dippin the rx or balloning it?

 

[Monkey Wrench]

Good for you! Just make sure the TX and RX crystals are the same, and you're stylin!

I say balloon the RX, rather than dip it. I think there's too many crevices for the dip to get into. Better yet, get a radio box, then you don't necessarily have to worry about it (unless your mud boggin' or something).