Nitro TC3

[Chewy078]

Is this a good engine for the NITRO TC3 (O.S. .12 TR w/10J Slide-Valve Carb) Will I have to cut down the shaft ?

 

[shadey26 ntc3]

Thats a good mill . If you get the SG shaft it will drop right in. If you get the short shaft it might have to be cut just a little. If you have the rtr and you get the short shaft, your gonna have to get the op clutch nut for your ride. The stock mill has a SG shaft. Get the SG a put the 5 bucks towards your new mill. hope this helps:write:

 

[Chewy078]

I ordered that mill to go with the NTC3 kit....So since i am not getting the RTR do i have to cut it anyway..