Nitro stampede used new to all this was

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Mason family

RC Newbie
Messages
1
Reaction score
0
Got it for cheap put over 100 into it just got the start stick an heard it start for first time but it wouldn't move lifted the back end up an wheels spun as soon as I sat I back down it dint move how to fix this problem? The lil vear just free spun then would stop or slow down when pulling back on trigger any help?
 

Attachments

  • 15582277084123825114708317796289.jpg
    15582277084123825114708317796289.jpg
    447.8 KB · Views: 72
  • 15582277443381461889887779406973.jpg
    15582277443381461889887779406973.jpg
    394.4 KB · Views: 72
Really looks like the wrong tooth pitch on the bell vs the spur. Odds are, your going to need a new spur and a bell for that spur. Traxxas vehicles use 1M and .8M/32P gears on some of their stuff. I think the stampede uses 32P like the old t-maxx. It appears that one has chewed up your spur gear.

Looking at parts lists, appears it comes with an 18T 32P bell, traxxas part # 4118 and a 66T 32P spur, 3166. Odds are, you will need to replace teh slipper pegs as they tend to get destroyed when you try removing/transplanting them, part 4685. Think you only need 6 for that, one in every other hole.
 
Also ,you can check the wheel pins an make sure the axle output shafts that come out of the trans.
set screws are tight!
The set screws are common to loosen up!
 
Back
Top