My build in progress, suggestions welcome

[CharliesTheMan]

I sure hope so. I'm looking forward to seeing how it looks with the Cheyenne wheels and Big Joe tires, but I like these factory wheel A LOT. I've got three cycles through it of getting it how and letting it cool down completely. I'm taking my slow time to do it right. I gotta go to the grocery store and when I get back I'm going to try and finish the break in process, its cloudy so I don't know if its going to start raining or not, but if it looks like it might I'm not taking any chances on getting my baby wet.

 

[Rolex]

I'm taking a break, but right now my Savage has been reduced to an assortment of chunks. Front end and rear end intact but everything between that is out since both the side frames are off. I still haven't opened up the trans, but it's out and waiting.

 

[CharliesTheMan]

about done with break in, on ebay searching for a roto-start system lol

Well I finally got her on her wheels and she's done beautiful. I'm going to buy a back up glow plug igniter that runs on C batteries. I had mine fully charged but it ran week after using it all day and I'd like to have a backup. I wish I would have thought to wear gloves sooner. I may not need a roto-start after all. I just got aggravated because I had to keep cutting it off and restarting it durin break-in.

 

[Zachary]

I'm taking a break, but right now my Savage has been reduced to an assortment of chunks. Front end and rear end intact but everything between that is out since both the side frames are off. I still haven't opened up the trans, but it's out and waiting.

Stalling..........

 

[Rolex]

Stalling..........

LMAO...
Definitely not a problem with stalling. It hasn't even been started yet.

 

[Mattyfats420]

the best thing i like about this truck besides the big block hehe. is that the dirt bone tires actually have little tiny dogbones on them lol