Luke's Dual I-Beam 3D printed RC PreRunner.

[Lukedavis]

well, i have to get some screws and such to get it put together, then i have to round up electronics, then i have to find out a way to mount the body, then i have to get some bearings. this build is far from done.

dang.

 

[Finesavageboy2]

Well, I'll be looking forward to it

 

[blaster27]

Can't wait to see the end job. Nice.

 

[luke66]

Hmm, a month later, what the heck is Luke up to?
Anywho, I've got the front I-beams built. I dont have pics yet cuz the truck is at home and I'm like 10 hours away. I need bearings.

 

[Lukedavis]

Hmm, a month later, what the heck is Luke up to?
Anywho, I've got the front I-beams built. I dont have pics yet cuz the truck is at home and I'm like 10 hours away. I need bearings.

That's also how mine is going

 

[luke66]

This truck needs help. Needs about 30$ of bearings and stuff to be built into a roller.

But.

I just am not workin on this ATM.

 

[luke66]

So, the designer posted a new version of the rear end that could use a rear axle from a WLToys. So I printed that all off and plan to buy all the stuff to make it a roller soon. Unfortunately a 313MM crawler body costs crazy money.

 

[luke66]

Got a bit more of the rig done. Still have a decent amount of work but most of the parts left (minus electrics) will be cheap.

 

[HPIguy]

Hmmm, wonder if there's a version to use an SCX rear axle? I have axles and trans in the garage.

 

[luke66]

Not currently. But anything is possible.