I noticed the artr ax10 has bent links only in the rear. I picked up a set of bent links from Joe at EEM, and I was wondering if there were any advantages or disadvantages of running the bent links only on the rear of the truck? Or would it just be better to run the bent links on both ends? The one thing I didn't like about them is the driveshaft stayed lower than the links. On the rear I just pivoted the axle a little by adding a spacer and longer screw in to the three link on the axle, that pretty much took care of that problem. But if I do that to the front it would put the steering links way low at a bad angle that would get hung up on everything.