Its the screw (alan key head) that fits in the hole which enables the back drive shaft to be locked in place so that it stays in permanent 4wd.. at the moment, its trying to drive in 2wd.. NOT GOOD when its kicking 3bhp!
PLEASE HELP ANYONE?!
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
HPI Savage 4.6 (PART IDENTIFCATION?)
- Thread starter CallyAkn
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Its the screw (alan key head) that fits in the hole which enables the back drive shaft to be locked in place so that it stays in permanent 4wd.. at the moment, its trying to drive in 2wd.. NOT GOOD when its kicking 3bhp!
PLEASE HELP ANYONE?!
86094 is on the transmission side and the 86095 is on the differential side, when you replace put some locktite on it.
- Thread starter
- #5
So the part I'm showing in the picture is the shaft screw for the transmission side yes?
If it's the one I'm pointing at in this picture, then yes.
