Hpi NMT2 went for a swim.Help!!!!

[nitroking]

Ok well i was driving the truck and it cought a hump and flip well it rolled back over qnd i keeped driving,The batts got knocked out and it took off fly and dediced to land in a drainage ditch full of water up side down well it shut off.We took it back to the shop and i tok the head and roto start off.i pumped all the water out.And now i have the engoine in front of a small heater i a pump a couple ounces of fuel through the engine with out the head.I dont have anymore after run oil.What could i do more to prevent rust?

THanks
Jeff

 

[RCDad]

WD40 maybe?

 

[kyosho138]

wd40 will work.. if you know what the wd stands for in wd40 then ull know why it works

 

[olds97_lss]

Yeah, just spray a coat of wd-40 in there. As soon as it dries, fire it up and let it warm up and heat any residual water out of it.

 

[stinkfist]

wd40 will work.. if you know what the wd stands for in wd40 then ull know why it works

Water displacing

 

[nitroking]

Would CRC work?

 

[olds97_lss]

What's crc?

 

[nitroking]

Its called CRC-5 i think i have like 3 cases of it,The spray cans had chinese labels on the and when peeled away it sghowed it was Crc which i think is like Wd-40 it is stronger and works alot faster

 

[Rolex]

CRC rings a bell. I'm pretty sure it's about the same. More importantly, open the reciever case and make sure everything is dry. Same for the battery pack and servos. One tiny drop, anywhere in the electronics or a connector can become a nightmare issue.

 

[psunitro]

CRC rings a bell. I'm pretty sure it's about the same. More importantly, open the reciever case and make sure everything is dry. Same for the battery pack and servos. One tiny drop, anywhere in the electronics or a connector can become a nightmare issue.

Yup,its much more than just the mill you have to look at for. The CRC is a brand name, they make many different products. They do make a penetrating oil,not sure if they make it as wd-40. Just make sure EVERYTHING is dry. Good Luck.