nitromonster420
RCTalk Rookie
i have a tmaxx 3.3 an just did the engine replacement plan an got my new engine an its a 3.3 an it starts but keep stallin an i can't et it to idle an it just wants to take off or stall what do i do
Welcome to RCTalk
Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
brad55102
RCTalk Addict
make sure your carb is set for break in
HSN= 4 turns out
LSN flush
and check your gap
HSN= 4 turns out
LSN flush
and check your gap
nitromonster420
RCTalk Rookie
- Thread starter
- #3
done all that its frustarting me I've done everything i first installed an it didint even wanna start now it starts bit stall after i lef toff the gass an some times when i give it gas it stalls i dont understand
Sounds like your pretty rich and your idle needs bumped up to compensate. That's typical for the first few tanks of a new engine.
Do yourself a favor and get an external glow heater if you don't have one. Then you can start it and leave it on the engine as it runs for a little bit to help keep the plug from fouling out while you ramp up the RPM's.
Do yourself a favor and get an external glow heater if you don't have one. Then you can start it and leave it on the engine as it runs for a little bit to help keep the plug from fouling out while you ramp up the RPM's.
