Check out my 4s Rusty

[Pfaulk54271]

Weve had this truck for over 10 years, first run on this power system will be this afternoon.
??

 

[olds97_lss]

Very clean setup. Can't imagine those slider axles on the rear will hold up too long. When I converted my eJato, I was running 2S with the traxxas 3500kv motor. The axles lasted 30 seconds. Then the plastic single speed conversion lasted 2 minutes.

Now that I have traxxas cvd's and a steel single speed conversion, it holds up well to 3S and a 3200kv 3660 motor with trencher 2.8's on it.

 

[WoodiE]

first run on this power system will be this afternoon.

So how did the first run go?

 

[Pfaulk54271]

So how did the first run go?

It was a little slow with that gearing setup, now its setup like this and is ridiculously fast. It now goes fine on 3s and 4s is just insane.

 

[LongIslandRC]

Very clean setup. Can't imagine those slider axles on the rear will hold up too long. When I converted my eJato, I was running 2S with the traxxas 3500kv motor. The axles lasted 30 seconds. Then the plastic single speed conversion lasted 2 minutes.

Now that I have traxxas cvd's and a steel single speed conversion, it holds up well to 3S and a 3200kv 3660 motor with trencher 2.8's on it.

I'm sure they're gonna disintegrate when I put the power to em. The MIPs are waiting in the wings. FLM makes the best CVDs for Rusty but they're costly. By spring time, they'll be in place on Rusty.

 

[olds97_lss]

Didn't know they had a batch of stuff for the rustler. $88 isn't too bad considering what your getting, if they stock them again:
http://www.fastlanemachine.net/proddetail.php?prod=FLM26720

 

[LongIslandRC]

Didn't know they had a batch of stuff for the rustler. $88 isn't too bad considering what your getting, if they stock them again:
http://www.fastlanemachine.net/proddetail.php?prod=FLM26720

Individually the parts are priced right, but pile em together and you gotta make some choices. If I didn't already have MIPs on standby, the FLM shafts would already be in effect.✌?