Hey guys, I have managed to smoke my 2 speed again.
The first time, it blew the wide ratio gear set. I replaced it along with the primary clutch.
Second tank in and it blows again. This time the wide ratio gear set stripped, the pins flew out of the primary clutch and the bearings on the...
Hi All : I was out running my 4-tech on a wide open Paved parking lot @ my Local Park... after about 10-15min into running... My 4-Tech would not move Engine running normal engine sound's @ 1st I thought I threw a drive belt...
upon shutdown & popped off body upon closer inspection the gear was...
I just bought a new 2 speed tranny and have a few questions? on the side with the spur gear it says to use the diff cup number 86272 is it the same diff cup on oppsite side? also the shifter rod that goes into tranny has a brass collar do i have to open tranny to put it in or what do i do? any...
I just installed a hpi two speed trans in my hpi nitro rs4 3,and my question is the car rolls fine in the foward direction,but when i push it backwards it wants to drag all 4 wheels. Is this normal,i didnt notice that issue with the single speed trans. All the gears match up fine and there isnt...
How does a two speed gearbox/tranny work on nitro vehicles? What causes it to change when it does? Are there different types of "gear change" on different vehicles?
Any info is greatly appreciatad :D thanks guys!
does anyone know what the factory settting is for the adjustment screw on the clutch is? Ever since i picked up the 3.3 transmission i could never get the truck to shift properly, sometimes it would shift sometimes not and since i just had to pick up a couple new gears i would like to bring it...
What exactly does this do? Is it to change the transmition from a nitro to work with a brushless or is it to make a E-Revo into a two speed or single... what exactly is it for? Btw, sorry to sound like an idiot but the specifics on amazon ain't helping.
can someone tell me the ideal settings for low speed needle and high speed needle from fully closed position?
i have ran in my buggy but now it seems to be running slow.
also wats the go with the disc break? does it even work, my buggy cuts out when i push forward on the trigger. is this...
I used it in my Savage for about 1/2 gallon until i ordered the 3 speed transmission. Transmission was working perfectly when removed and has been sitting in the house ever since so there shouldnt be a problem with it. If you have your engine tuned correctly the shift point should be dead on...
hey all, i gota gv cage nitro a few months back and its my first rc car I've ever owned. i noticed that the gear box is locking up and the wheels wont turn at all so i took it apart and the gearbox seemed fine, also it runs fine with only rear wheel drive, but is impossible to control. the front...
I just finished breaking in the truck and out of the box the tranny shifts on the late side. According to the directions it says to have to black screw exposed and adjust accordingly. I tried to get the black screw exposed but I was only able to get the gold screw exposed. Is there any trick...