throttle

Hey everyone so my throttle servo decided to pooch out on my frankenmax it was a spektrum one wondering a good recommended servo

I am looking to pick up the xtreme racing cf throttle mount kit. I have a new revo 3.3, and wanted to make sure this mount kit works with the stock mounting holes, to me going by the photo only it does not look like it would be wide enough to match up with the holes in the chassis. Also where...

I know it may be a big ask but at the current time all of the above stated are either on their last legs or about to die on me- especially the servo. Living in the u.k so try and include shipping too. Asking for nothing fancy, just something that works!

So when i am on the brake thebuggy idles okay and its all good but if i let off the brake, even though the carb doesn't open at all, it wants to haul ass. thats 1mm carb opening and it wants to really take off. once i start driving it and i give it gas it produces a lot of smoke and stalls out...

Hello, I recently took on the seemingly easy task of choosing a new throttle servo for my HPI trophy 3.5 to put on my Christmas list. I am looking at a budget of under £30 ($47) I first looked at the brands I knew; Savox, Hi-tec e.t.c and was utterly stumped- THERE WERE HUNDREDS OF THEM!!! I...

just joined having problems with my jammin jpx .21 running the car for 2-4 minn when I give it throttle in stalls I've gone rich and set it lean checked for leaks air and fuel any tips goin to give up on these italian motors

i got a VX-18 engine whenever i try to go really fast the engine shuts off. what must i adjust here?

Hi guys i have a bit of a problem(hopefully small).i just bought a used savage x 4.6 and the guy said it probably needed tuning as it has sat for a few months. i got it fired up but you can only give it about half to three quarters throttle or it just dies no matter how warm the motor...

For those of you who havent done this upgrade, ill tell you i never realized how much of a piece of sh*t the regular savage linkage is unil i upgraded to this linkage upgrade. the throttle and break response is night and day now, a world of difference, and it only cost me 15 bucks! i bought all...

Good evening everyone. I have a new Revo 3.3. The engine was broken according to Traxxas DVD that comes with the truck. Even during break in the throttle would hang for 2 to 3 seconds before returning to idle. I have went back to factory settings and started with the High speed needle and...

Just traded for a used T Maxx. The end of the throttle linkage (part 5243) bumps into the EZ Start motor. There is plenty of clearance on my other T Maxx. Any suggestions on why the motor sticks out too far and how to cure the problem? It appears to be assembled properly and the EZ start...

I am working on getting my old Duratrax Maximum ST up and running again. I have the motor unseized, have replaced some things here and there and while I am waiting on some fuel to come in the mail I figured I would adjust the throttle linkage. I am assuming it should be adjusted so that at...

My truck has gone bad these days, whenever it's on the ground, and i give it throttle (light or full) it dies. If i hold it in my hands and the wheels doesn't touch the ground, i can open the throttle at full, brake, do anything.. and it won't dies. what could cause this ?

My friend has a thunder tiger tomahawk st and his throttle servo broke after a week of having it so we put a new one in and now one week later it has gone again. Any ideas what could be wrong with it? Because I don't think that is normal for it to break twice in two weeks. Any comments would be...

Just bought a new Nitro car. Its the Tornado S30 .18 engine. Every time I start it it runs high idle. I can't figure out how to turn it down properly. I tried to adjust the idle screw but no help.

I have a Cen .30 engine in my Cen C1 Matrix 1/8 scale buggy. It starts right up, runs like a champ until I go full throttle, then it dies. I've shortend my fuel and exhaust lines because I noticed air bubbles in the lines. That didn't help. But it did take care of the bubbles in the line. I've...

Hello Everyone. Well as you can see this is now my 2nd post, being a newbie to this R/c Nitro Thing. Give you all a little history of what I have been doing. I brought a Kyosha Inferno MP-777 rolling chassis. I have brought a New Engine, Throttle Servo, Steering Servo, Exhaust pipe, Fuel Lines...

First time poster and new in the nitro RC game so I'm kinda clueless right now. When I give my t maxx full throttle it Boggs down and wants to die. I've adjusted the hsn both ways and can't seem to get it to run right. It's not just at high speed that it Boggs either. I can have it idling then...

Hi all. Thanks to everyone's help I was able to change my throttle servo lately (Kyosho DBX 2.0). Today I bought a new airfilter. I took the car for a spin and a bit of fine tuning. After 15 minutes, I got every needle in its right position, so I put the body/cover on. Right after that, I...