picco

I am convinced that I should get a picco .26, however, I am confused as to which is better. The 51223 seems like it is ez start ready and perfect for the revo. On the other hand everyone seems to be using the 51225 so what should I do here? which is better??

my revo with picco .26 reddot and rd 61530 bb exhaust,18/38 gears and wide ratio in the tranny is wheeling when it hits 2nd is that normal and do i need to go to center diff or is it that normal? think it is tuned close alittle on the rich side lots of smoke and glow plug is wet on ring around...

I was wondering if anyone is using any kind of roto starter or shaft style starter on their Picco 26? I tried the TIGER DRIVE S682 and it didn't fit. it hit the control arm. Is there another one I can use?

I just got my dynamite 053 side pipe to mount on my picco .26 It came with 3 small springs and 1 large spring. Do the 3 small springs attach header to pipe and the 1 spring wraps around the engine head? I tried this way and it seems the header doesn't attach to the head very well. Should I...

Does any know which way the picco .21 max rotates?

I got my picco .26 and new era mount kit I began mounting it, and it seemed to go pretty smooth. I got to the point of fitting the throttle linkage, and it seems to shut fully pretty good but when I hit the throttle it only opens up about half way and If i assist it with my finger I can...

What header gasket do I need to use for the picco .26 with a big block header and pipe

I have a Picco 26 i bought used off the forum. Comes with a New Era mt for Revo a Ths pipe and a mount that came with it $100 shipped. When i first got the engine it ran poor, but found some crud behind the needle, Ran it a couple times and then bought a XXL so i put the 3.3 back in the revo