Search results

The problem is you engine is getting tooo much fuel. Read the engine instruction manual and set engine back to factory settings. When starting engine only prime 2 -3 times before putting on ignitor then 2 -3 more time until you hear it pop off. then start.

FYI! One way bearings don't leave shavings; stripped gears do. One way bearings always fail when the roller pins fall out. He replace the pull starter with a gear drive system after breaking the pull start rope.. The engine ran fine for a while and now it doesn't. A heat gun isn't going to...

Remove the glow plug and try and turn over by hand. It should spin freely and have some resistance. If it doesn't move then you will have to remove the backplate and see what the problem is?

There is nothing wrong with the drill start option if you set the clutch on the drill to slip. I usually set the clutch 1/2 way so it slips when the engine floods. I suspect the shavings are from the starter. The engine is probably not set correct on the needle settings causing the flooding and...