Search results

Try going down to a 50T spur. Should give you more speed. STRC makes CNC machines aluminum center drive shaft hubs. And traxxas makes an aluminum center drive shaft. STRC and traxxas both sell aluminum steering bell cranks, but use bearing instead of the plastic bushing the stock one uses...

I like it man! I just used the air flow from under the bottom front of the body and ducted it to the motor and esc. And let it discharge out the back by cutting off the “tailgate” if you will. I’m on the VXL6S power system. So I don’t struggle with heat at all between the larger can and esc and...

I understand. I have no experience with this though. On my build (6S 4x4 slash) that’s what I experienced. What I did was drop the body as low as I could on the chassis, then get the ride height as low as I could, align it, then used abs plastic, flex seal, duct tape, and a heat gun to make...

Run a Y adapter to the esc and run both fans off the Y adapter. I don’t think cutting a hole or cutting out the windshield is a good idea; it can cause the body to act as a parachute and cause it to lift and flip over at speed. Upgrade to an aluminum steering bell crank should give you...