Yeah i like it. I'm sure the neighbors do to. Ill have to have a competition with there gardners when they show up at 7am on whos rebs up better
So decided for now for the scx10 chassis we will go ahead with electric for sure and get another setup for the gas. I need help as far as the parts go...
Oh they are a blast. Yeah growing up we drove odysees all the time. One my dad put a suzuki katana street bike engine in one and man it was awesome. They are single seater sand rails. But yeah they did start out kinda like a mix between a golf cart and john Deere transport vehicles. Then yeah...
Yeah side by side or utv. We converted a uhaul actually and added a winch in the back, though the can am has one Built in on the front. But removed the ramp from center and added a second and made two slots on either side for them to slide into, and installed air suspension on the back. And for...
Yeah i want to do the same. Its what we wanted to make a rock crawler out of but the chassis we got isnt low enough for the weight. But in the mean time, we like to play around in this(second image)
This is a different motor we got running. The other ones still giving us problems so we put it on the side for now. So i went and mounted this one up and took a short clip of it. Now we are going to build a mount display for it so we can fire it up whenever. Got a larger starter though for it...
I actually figured out the issue, but trying to figure out the best way to go about getting it properly place. Its the hall sensor positioning. I went and test the cdi in firing position with a voltage meter and that started lighting up so i started moving the hall sensor around while keeping a...
It came with 2 extra hall sensors. I already replaced the one that was on there. I just tried firing it up to test it again and nothing. This time i rotated the distributor cap to see if maybe it was the timing of where the cap was alighned with but it didnt even putter at any point so its gotta...
Yeah just made sure the tdc in piston 1 was in line. I believe its the cdi with a good amount of confidence. Got 3 18650 powering it and when i turn the engine the spark isnt occuring on the spark plug at all as it passes the bridge in the distributer.
The engine is the 32cc inline 4 cylinder 2...
I wish i knew the timing or where the piston needs to be in accordance to the distributer. Hoping its not a timing issue. I'm gonna try firing it up tomorrow. I drained the oil today and will refill tomorrow just to make sure i put the correct amount in. If its none of that than i would guess it...
Well i went to check the alternator and make sure it was where it should be and felt the wire to the hall sensor and the wires pulled right off of it so i replaced it just havent tested since. But also i noticed when turning the engine over the lubrication lines are not pulling any oil through...
We just picked up the 32cc Inline Four Cylinder Water Cooled Gasoline Engine, got the thing setup, got the batteries put in for the plugs and fan, annnnd, wont start.... ill go take a photo of the worst setup made by man. But its just tempary to get it working first, if we can. Kinda still new
😥
Yaknow, be kinda unique to mount this on a bbq grill as the ignition and rotisserie driver. For over the top way to put it to use, but you would have the coolest bbq setup in town
Yeah but they sell them with the engine, and uf u want just the rest of the kit without the motor, you dont get the servos and electronic setup frim what i saw
Figure uf i dont end up using the engine on a car or something i should make a campfire generator ir something slightly usefull thats...